Virtual Ap No Ubnt

Vou anotar aqui o que achei sobre o assunto até que esse texto vire um bom artigo.

cli:

wlanconfig ath1 create wlandev wifi0 wlanmode ap
iwpriv ath1 ap_bridge 0
iwconfig ath1 key off open
brctl addif br0 ath1
iwconfig ath1 essid INTERA_03A
ip link set ath1 up

1) Add a new ‘bridge’ port (use the next port number in line, eg ‘port.4’ and next device number in line, eg ‘ath1’):

bridge.1.port.4.devname=ath1 bridge.1.port.4.prio=20 bridge.1.port.4.status=enabled

2) Add in the ‘ebtables’ options (incrementing the .2. number as applicable and using the added device number):

ebtables.sys.eap.2.status=enabled ebtables.sys.eap.2.devname=ath1 ebtables.sys.arpnat.2.status=enabled ebtables.sys.arpnat.2.devname=ath1

3) Add in the ‘netconf’ port (incrementing the .4. number as applicable and using the added device number):

netconf.4.up=enabled netconf.4.status=enabled netconf.4.role=bridge_port netconf.4.promisc=enabled netconf.4.netmask=255.255.255.0 netconf.4.mtu=1500 netconf.4.ip=0.0.0.0 netconf.4.hwaddr.status=disabled netconf.4.hwaddr.mac= netconf.4.devname=ath1 netconf.4.autoip.status=disabled netconf.4.allmulti=enabled

4) Create the next ‘virtual’ radio device using the added device number and the next virtual number, eg virtual.1.:

radio.1.virtual.1.status=enabled radio.1.virtual.1.devname=ath1 radio.1.virtual.1.mode=master

5) Create the next ‘wireless’ section using the device number and specify the new SSID:

wireless.2.wmm=enabled wireless.2.wds.status=disabled wireless.2.status=enabled wireless.2.ssid=NEWSSID <= CHANGE TO ACTUAL SSID OF VIRTUAL AP wireless.2.l2_isolation=enabled <= CHANGE TO ‘disabled’ IF NO ISOLATION IS REQUIRED wireless.2.hide_ssid=disabled wireless.2.autowds=disabled wireless.2.authmode=1 wireless.2.ap= wireless.2.addmtikie=enabled wireless.2.devname=ath1

6) If no security is needed; you’re done here; save config file and upload to device.

7) If security is required; add the following config appending the section number:

aaa.2.br.devname=br0 aaa.2.devname=ath1<= CHANGE TO ACTUAL DEVICE OF VIRTUAL AP aaa.2.driver=madwifi aaa.2.radius.auth.1.status=disabled aaa.2.ssid=NEWSSID<= CHANGE TO ACTUAL SSID OF VIRTUAL AP aaa.2.status=enabled aaa.2.wpa.1.pairwise=TKIP CCMP aaa.2.wpa.key.1.mgmt=WPA-PSK aaa.2.wpa.psk=PASSWORD<= CHANGE TO REQUIRED PASSWORD OF VIRTUAL AP aaa.2.wpa.mode=2

fonte: Fórum UBNT / Binary Heartbeat